Many customers in the hollow glass production line responded that after purchasing the insulating glass production line, they were dispatched by the manufacturers of insulating glass production lines to debug. However, they did not know how to determine whether the insulating glass production line had been fully tested and normal production. Here, Parker's machines serve as customers. Responsible principle, announce the debugging process in an all-round way, hoping to solve doubts for everyone:
1. Place the insulating glass production line lightly in the installation position and correctly place the position and sequence of the various sections of the production line.
2. Level the body of the insulating glass production line. Adjust the height of the leveling bolts on the base of the machine so that the conveying roller and the supporting surface of the nylon wheel support the same height. The backrest wheel on the inclined frame is coplanar. Each section is relatively parallel, and then the nuts are locked.
3. Connect and fasten the parts to be connected between the sections of the insulating glass production line and connect the driving chain from the infeed section to the cleaning and drying section. Place the fan and water tank correctly, and connect the air pipe and water pipe according to the water and air system diagrams.
4. Completely inspect whether all fastener joints of the insulating glass production line are loosened due to transportation shocks and fasten them piece by piece (especially if the connections of each terminal are loose).
5, grounding line with a cross-sectional area of not less than 6 square mm soft copper heart yellow-green insulated wire, grounding resistance is not greater than 4 ohms.
6. Switch on the gas source to check if the pipeline is open and damaged. Air source pressure requirements 0.5 ~ 0.8Mpa. Turn on the power test The rotating direction of each motor of the insulating glass production line is correct, and whether the driving sprocket of each segment is flexible and stable.
7. Place the operation switch in the “manual” position and perform a separate test on each device. Whether there is any damage during transportation, if there is any abnormality, the machine should be shut down and repaired immediately, and try again after troubleshooting.
The above is what we debug personnel need to do and determine to do the debugging of the insulating glass production line, choose the insulating glass production line, or choose the real strength of the manufacturers, only the strength of the manufacturers, the price will be the best, the price will be better, after all No one manufacturer has produced an insulating glass production line, which is rushing to close. If you say, manufacturers of insulating glass production lines still have to choose Jinan Parker Machinery Co., Ltd., with excellent quality and stable and reliable operation.
If you are interested in our products, please contact with us as following:
Shenzhen P-luck Machinery Technology Co,.ltd
No10-1, tongfuyu yongshengtai industrial park, Longtian Village, Kengzi town, Pingshan District, Shenzhen city
post code: 518112
contact person: lily shen