How To Install And Adjust Crimping Machines

- Mar 27, 2018-

This machine is a new model developed on the basis of absorbing the advantages of similar foreign products. The machine adopts gas, electricity, liquid coupling and operation control. Due to adopting a new mechanical linkage structure, the influence of oil pressure fluctuation on the quality of the assembly angle is eliminated, the assembly angle is completely synchronized, the group angle depth is more consistent, and the group angle is 90 degrees. The angle is more precise. In addition, the front and rear positioning are adjustable up and down, and the front and rear distance adjustable positioning device is suitable for processing profiles of different cross-sectional shapes and sizes.

 Installation and Adjustment Editing

4.1 Environment and Requirements

The gang angle machine should be installed on the indoor hard cement floor with dry, dust-free and non-corrosive gas.

4.2 out of the box in place

After unpacking, move the assembly corner with the packing base to the installation position. Remove the fastening screws on the base of the cornering machine and use the transport tool to move the assembly corner to the installation position.

4.3 Grounding

The angle machine body must be grounded. When it is grounded, yellow-green multi-color twisted strands and copper wires are used. The cross-sectional area is not less than 2.5 mm2. The resistance between the grounding body and the main grounding point should be less than 4 ohms.

4.4 power supply

Input voltage 380V, frequency 50HZ power supply.

4.5 Air source

The gas source is installed on the joint of the air source processing triplet on the side of the fuselage, and the air pressure is adjusted to 0.5-0.8 MPa after checking for no leakage.

4.6 Check the oil circuit

Open the rear cover of the airframe and the liquid level of the tank should be kept above the centerline of the oil mark to prevent the oil pump from emptying. A 120-mesh filter is used to remove impurities from